Hello Guest it is September 19, 2020, 06:31:12 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - kriehl

Pages: 1
General Mach Discussion / Mach 3 and a Grinder
« on: April 22, 2011, 06:35:50 PM »
I am looking for any information for using Mach 3 with a grinder. After facing the grinding wheel we need to set Z to zero so we can continue to grind. Is there a procedure that I am missing to do this routine? I found a couple of posts that mention that others are doing this but I can not find the posts.

Any help would be much appreciated.

Pages: 1