Hello Guest it is September 28, 2023, 02:55:54 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - wyb_506

Pages: « 1 2 3
21
I want to sell our machine to the end user, this machine uses Mach3 as control system, a question is :
it is easy to change a parameter for the end user,  while a mistaken can cause damage, so I want to only show the set up screen to our technic stuff, he can change the parameters by entering a password, but the controls in the screen will be invalid if he has no the pass word.
if any body can help me thank you~~~~~ ;D

22
hello every one. thanks a lot for a warm welcom,I'm a new one for Mach3, please help me ,thank you~~~

Pages: « 1 2 3