1
General Mach Discussion / Help!! can't get table display right on milling machine
« on: December 05, 2023, 04:00:06 PM »
I've used mach3 on a router and it was fine. Now I have converted a small table top milling machine.
On my router the spindle moves along the x y axis and the tool is at the intersect on the table display. But on the milling machine the spindle is stationary so the display just shows the x and y axis moving and not the position of the cutting tool. I set the home at bottom left.
My brain has switched off so Please help me out.
Merv
On my router the spindle moves along the x y axis and the tool is at the intersect on the table display. But on the milling machine the spindle is stationary so the display just shows the x and y axis moving and not the position of the cutting tool. I set the home at bottom left.
My brain has switched off so Please help me out.
Merv