Messages

1

FAQs / Re: motor movement

« on: January 27, 2014, 02:40:34 PM »

thanks for trying...

Bill

2

FAQs / Re: motor movement

« on: January 27, 2014, 02:37:10 PM »

tried that and restarted the software and no change

3

FAQs / Re: motor movement

« on: January 27, 2014, 02:16:56 PM »

kernel speed did not help my problem

4

FAQs / Re: motor movement

« on: January 27, 2014, 01:56:54 PM »

I have hade my motor tuning all over the place and still no movement

5

FAQs / motor movement

« on: January 27, 2014, 10:55:31 AM »

I have been using Mach 3 for a while now and my computer crashed. I reconnected another computer that I had been using to try my programs (simulating). I lost all my inputs and output configurations but that is not the real problem. I have gone thru the setup procedures and should have enough information for motor movement but do not. I can hear them react to commands but no movements. I do have them enabled in Ports an pins. Please help.

Bill