Hello Guest it is March 28, 2024, 01:42:56 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - renxiang

Pages: 1
1
General Mach Discussion / Mach3 cannot send out signal
« on: June 27, 2011, 07:13:19 PM »
Hello,
I have a problem, I connected the serial port to breakout board, but when I run Mach3, there's no signal sending out through the breakout board, nor the serial port. Any one knows the reason?
Xiang

2
General Mach Discussion / Re: Mach3 tool change
« on: March 29, 2011, 05:48:31 PM »
you mean the code G43, can I do it throught software? Since I don't want to edit the codes because it's too big and almost impossible to edit.
can I make any setup in Mach3? Such as the "Offsets(Alt-5)"?

3
General Mach Discussion / Re: Mach3 tool change
« on: March 29, 2011, 05:41:04 PM »
I mean after change the tool, how to compensate the offset of the second tool from the mach3 software, not from the code.

4
General Mach Discussion / Mach3 tool change
« on: March 29, 2011, 05:03:49 PM »
Hi everyone,
I came across a problem: in mach3 software, I want the new tool automatically go to origin point after change the tool. How can I set up it, suppose the second tool's position is (10,0,0) compared to the first tool.
Is there any method to set this in Mach3 software?

Pages: 1