Hello Guest it is August 03, 2021, 04:53:27 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - JackMath

Pages: 1
1
Mach3 under Vista / Re: Getting up and running in Vista
« on: December 30, 2011, 12:34:36 PM »
Thanks Jeff

Jack

2
Mach3 under Vista / Re: Getting up and running in Vista
« on: December 29, 2011, 12:47:22 PM »
Hi

I have the OS Vista 64 bit only. I heard somewhere that Mach3 must run under the 32 bit version. Is there a solution here, without having to buy a different version of Windows  ?

Thanks a lot

Jack

3
General Mach Discussion / Re: Home liimits problem
« on: March 17, 2011, 04:30:20 PM »
Thank for reply ostie01

I should specifiy that my problem is regarding Mach3 software home switches.

Jack

4
General Mach Discussion / Home liimits problem
« on: March 17, 2011, 02:39:30 PM »
Hi

In the ports and pins screen menu input signals, I have configured 3 home switches (X Y Z) active "high". In the home/soft limits screen, I have configured my table limits in inches with the autozero "on" and home negative "on" for both X,Y axis.

THE PROBLEM IS:  In the diagnostics menu the M1 M2 M3home appeared always "on" and can't refer all home. I have tried the override button in the setting menu and it didn't change.

What do I do wrong here ??

Thanks

Jack


Pages: 1