Hello Guest it is March 28, 2024, 03:57:52 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - homebilt

Pages: 1
1
Well greetings to start with! And if this is in the wrong location-I do apologize. I am extremely new to CNC operations and am trying to build a handwheel on Mach3 turn. I keep getting a pretty wild shape with G02 and G03 in that it loops and ends where I want it to, but not along the path I was hoping for. I am guessing I have "I" and "K" way off. I understand that there are probably a thousand ways to skin this cat, I am at this point merely trying to learn any one of them. Basic design is an 8" wheel with a web of 0.375 and then as it gets to the outer edge it transfers into a 1.00 diameter sphere. I have attached a .dxf file that shows the outside profile. The .dxf is rough as I wanted to leave the dimensions attached because this has a reverse curve in it. Again thanks ahead of time for any help I get!



Pages: 1