Hello Guest it is March 28, 2024, 03:02:24 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - moxy

Pages: « 1 2 3 4
31
General Mach Discussion / lazycam cut order
« on: April 23, 2007, 05:24:31 AM »
Hi Guys, When I post a gcode file using lazy cam I end up with quite a lot of "intercut jogging" which adds a lot of time to the job overall. I use the optomise option and that helps a bit but......... Is there a way that I can edit the cut order within lazycam or perhaps lazycam pro will include such an option. Any help?
Regards
Les

32
General Mach Discussion / Re: Acceleration problem
« on: March 01, 2007, 06:56:17 AM »
Hi Brett, I just checked and a tab does it all Thanks
Les

33
General Mach Discussion / MPG
« on: March 01, 2007, 06:52:45 AM »
Hi Brett, I got rid of it by selecting  the main Mach3 sceen but I'm still stuck in single step mode(which was what I was looking for in the first place). Will a tab bring MPG up again? many thanks
Les

34
General Mach Discussion / Re: Acceleration problem
« on: March 01, 2007, 06:21:03 AM »
Hi All, I have recently joined the forum and find it a great source of info. I just opened a query which resulted in a "Mach 3 now working with vista" display which I can't get rid of. Seems to be some sort of malacious code. Any advise other than a sledge hammer?  I also managed to bring up the pop up that allows you to control jogging etc (by accident.. had a schematic sheet lying on the keyboard and I don't know what was keyed in to do this.) Any suggestions?
Les

Pages: « 1 2 3 4