Topics

11

General Mach Discussion / lazycam pro

« on: September 24, 2007, 10:25:53 AM »

Hi Everyone,
                 I,m using turbocad version 4 (free download ) and find that lazycam pro does not seem to undrstand what an elipse is. I save my files as DXF and everything shows except the elipses. Tried saving as HPGL and all was well but scale was nuts. It started with a move about 580 mm and the whole job is about 120 mm. Any help much appreciated
Les

12

General Mach Discussion / lazycam cut order

« on: April 23, 2007, 05:24:31 AM »

Hi Guys, When I post a gcode file using lazy cam I end up with quite a lot of "intercut jogging" which adds a lot of time to the job overall. I use the optomise option and that helps a bit but......... Is there a way that I can edit the cut order within lazycam or perhaps lazycam pro will include such an option. Any help?
Regards
Les