Guest
Show Posts
51
Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!
« on: February 27, 2011, 09:06:36 PM »
Hi,
I have had a 16" by 24" CNC Mill since 2006 with a proprietary German serial interface and CAM interface. I made due, but there seemed to always be a new hurdle. I use BobCAD V21 to design and create the g-code.
This past weekend I removed the serial interface and replaced it with a CNC4PC controller. Not as easy a job as I thought because the driver/power supply board had no documentation, but on Monday I am going to make smoke or make chips. No going back now.
Steve.
I have had a 16" by 24" CNC Mill since 2006 with a proprietary German serial interface and CAM interface. I made due, but there seemed to always be a new hurdle. I use BobCAD V21 to design and create the g-code.
This past weekend I removed the serial interface and replaced it with a CNC4PC controller. Not as easy a job as I thought because the driver/power supply board had no documentation, but on Monday I am going to make smoke or make chips. No going back now.
Steve.