Hello Guest it is September 26, 2020, 06:32:17 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Bob Braeking

Pages: « 1 2 3 4 5 6
51
General Mach Discussion / Homing Trouble
« on: February 20, 2011, 01:15:20 AM »
I am having difficulty with homing.  When "Ref all" is hit the Z homes normally......hitting the switch and backing off.  The Y hits the switch and triggers a "limit switch active" message.  I have all my homing/limit switches wired in series to pin 10 active low.  The Y and X were homing corrctly until I added the switch for the Z axis.  I disable homing on the Y and th X is doing the same thing......hitting the switch and locking up the machine.  I have the auto limitoverride on.  What in the wide world of sports is going wrong?

Pages: « 1 2 3 4 5 6