Hello Guest it is March 29, 2024, 08:21:00 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - andmar2005

Pages: « 1 2
11
General Mach Discussion / DRO tool used
« on: February 19, 2011, 04:33:15 PM »
hello
DRO what number to use in turning the panel to display information the number of offsets used at any given time
such as M6 T01 1911
T01-No tools
11 - used thistle (just at the table for the tool T11), but loads it to the tool T01
M6 - change tools
hi

12
General Mach Discussion / Re: OEM codes for buttons, DRO's and LED's
« on: February 19, 2011, 01:23:03 PM »
hello
DRO what number to use in turning the panel to display information the number of offsets used at any given time
such as M6 T01 1911
T01-No tools
11 - used thistle (just at the table for the tool T11), but loads it to the tool T01
M6 - change tools
hi

Pages: « 1 2