Guest
Show Posts
1
General Mach Discussion / Stepping problem
« on: February 10, 2011, 10:33:22 AM »
Hi,
I have this problem with the connection between PC<->Driver. You can se how I hooked up the drivers and BoB in the attachment.
The drivers and Bob are supposed to be wired like this: http://www.brundin.biz/images/datasheets/CW230Elschema1.pdf and i cant find anything wrong with my wiring.
If I short-circuit the P2 and GND the motor will step and If I short-circuit P15 (eStop) to ground the eStop gets triggered so it seems like I have a connection.
Lets get to the problem..
When I jog, the DRO is counting but the motors wont move. I hope anyone here could help me
(I have checked the active low checkbox.)
Thanks in advance
Niclas
I have this problem with the connection between PC<->Driver. You can se how I hooked up the drivers and BoB in the attachment.
The drivers and Bob are supposed to be wired like this: http://www.brundin.biz/images/datasheets/CW230Elschema1.pdf and i cant find anything wrong with my wiring.
If I short-circuit the P2 and GND the motor will step and If I short-circuit P15 (eStop) to ground the eStop gets triggered so it seems like I have a connection.
Lets get to the problem..
When I jog, the DRO is counting but the motors wont move. I hope anyone here could help me
(I have checked the active low checkbox.)
Thanks in advance
Niclas