1
Mach SDK plugin questions and answers. / Re: Mach3 Camera Plugin video window
« on: March 15, 2020, 05:57:34 PM »
And so the saga continues...I was using the CNC machine this morning and the camera plugin was taking an easy 8 to 9 seconds to load. And I reloaded it about 10 times, just to get an average. So I did a search for "camera plugin" on this forum and I came across someone else, not with this issue, with a problem using Klaus' ver 3 plugin. It came out in the thread that he was using an AMD machine and when he switched to an Intel machine, all was good.
I am using an AMD Sampron 140 processor. I switched back to ver 2.14d and the plugin loads consistently in under than 2 seconds. I did have to slow the refresh rate down to 80. Any faster and the jog would not work smoothly.
As an aside, I noticed in ver 3 that the fastest refresh rate was 100.
Any comments would be welcomed.
Thanks.
Rick
I am using an AMD Sampron 140 processor. I switched back to ver 2.14d and the plugin loads consistently in under than 2 seconds. I did have to slow the refresh rate down to 80. Any faster and the jog would not work smoothly.
As an aside, I noticed in ver 3 that the fastest refresh rate was 100.
Any comments would be welcomed.
Thanks.
Rick