21
LazyCam (Beta) / Re: AutoCAD and LazyCam
« on: February 05, 2011, 11:12:08 AM »
I went ahead and looked for a raster to converter program, found a few and tried them. One worked OK so far but cost money and can't go that route since I would still need to edit in AutoCAD. I kinda like the tracing method you mentioned and I will try that later. I really wish my teacher would have taught us AutoCAD with Inventor instead of going through the history of graphics and and crap. Thanks for the help and will hopefully get all this figured out. I have a Taig mill setup with Mach3 and I have cut a few things already, I can program but I don't have much talent in the drawing area. I'm attaching the dxf of what I have come up with so far. Thanks Again!