Hello Guest it is April 17, 2024, 11:37:56 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - cassulo

Pages: « 1 2
11
General Mach Discussion / Re: Beta Testers
« on: February 11, 2011, 07:51:50 AM »
Gary i just got a new cnc 4x 8  mill running and am using mach 3 as driver software, i am used to modlemaster type mills so this is all new i am a beta tester for 2011 artcam and i just saw your post how are they working? will they both  3xs and 4axis rotary will be included i would like to have tested for you my mill rotary is not complete yet but should be in the next week or two, i am yet to try a post pross from artcam yet i ave no tool changer either. the mill is just simple set up so any one could run . i am just not up on witch mach3 posts to use from art cam yet. 

12
as a new member  i have a question i am new to mach3 as a driver for a new mill cnc , here's the deal i have tyred every thing to install the driver it won't. i am on a windows 2000 pro set up and hooked up via printer port and the address is correct . cant install cant test driver and performance as it says and most of all i cant remove anypart of the program when i go to remove driver it doesnot show it. lost .  ::) ps like the spell check...

Pages: « 1 2