11
General Mach Discussion / Re: mach3 turn spindle dro not working, spindle speed changing while jogging
« on: April 07, 2011, 02:14:47 AM »
Thanks a lot
Yes the pulley ratio is set to 1.
Is this the file that is needed to look at my set up mach3 turn.xb74
If it is how do I send it to the thread.
I tried to cut and paste but no joy. I can e mail as an attachment but to get it on here is beating me
Geff Ford Cape Town
Yes the pulley ratio is set to 1.
Is this the file that is needed to look at my set up mach3 turn.xb74
If it is how do I send it to the thread.
I tried to cut and paste but no joy. I can e mail as an attachment but to get it on here is beating me
Geff Ford Cape Town