1
General Mach Discussion / Axis work in mill but not in plasma
« on: April 14, 2011, 03:15:40 PM »
Hello all, I, like everyone else am new to this soft ware and can't seem to get it configured just right.
I have a hobby CNC kit and am trying to configure your software to it. The problem I'm having is when I'm in mill only two axis work, y and z, when I'm in plasma, only y and x work. I have the same settings in both mill and plasma but cant get all three axis to work. The machine is technically a 3 axis plasma but I'm so desperate to figure this out i was trying it in mill with the steppers not connected to anything. any advise would be appreciated.
I have a hobby CNC kit and am trying to configure your software to it. The problem I'm having is when I'm in mill only two axis work, y and z, when I'm in plasma, only y and x work. I have the same settings in both mill and plasma but cant get all three axis to work. The machine is technically a 3 axis plasma but I'm so desperate to figure this out i was trying it in mill with the steppers not connected to anything. any advise would be appreciated.