1
General Mach Discussion / ofset g55
« on: January 13, 2014, 03:19:24 PM »
when i use G55 and i change the Z coordinate to cero and then to 8 or any value and then cero again to get my new cero on Z. my part does not have the height expected.seems like save the last height on z axis.
i lost my old computer with XP WORKING without any trouble.
and now i am using windows 7 32 bits with a PCI PARALLEL CARD.
motor are configured and the accuracy too.
ANY IDEAS
MACH VERSION 3.043.066
Thanks
Antonio
i lost my old computer with XP WORKING without any trouble.
and now i am using windows 7 32 bits with a PCI PARALLEL CARD.
motor are configured and the accuracy too.
ANY IDEAS
MACH VERSION 3.043.066
Thanks
Antonio