11
General Mach Discussion / Re: "probe tip diameter is invalid"
« on: January 10, 2011, 08:38:34 PM »
Yes, I am using the Tormach provided version of Mach3. I thought they were pretty similar with some addons and pre-configed for Tormach.
As for the special screen you are talking about, is it the offset screen? If so... the offset screen still updates the tool table... right? Tormach recommends using Tool #99 for probe but you can pretty much use any # you wish.
Thanks for your help... I might have to give Tormach a call... was hoping to get it working tonight.
Ken
As for the special screen you are talking about, is it the offset screen? If so... the offset screen still updates the tool table... right? Tormach recommends using Tool #99 for probe but you can pretty much use any # you wish.
Thanks for your help... I might have to give Tormach a call... was hoping to get it working tonight.
Ken