351
General Mach Discussion / Re: Help on setting up ToolOffsets
« on: February 28, 2008, 05:21:04 PM »
Thanks for your help. I think the G43 thing was getting me. I have added it to my init string. This should help.
Are all tool offsets incremental from T1? So, even if you are not using T1, you need to use T1 to set the base offset for all the tools?
Thanks,
Joel
Are all tool offsets incremental from T1? So, even if you are not using T1, you need to use T1 to set the base offset for all the tools?
Thanks,
Joel