1
General Mach Discussion / DC-03 DigiSpeed GX V3
« on: July 07, 2011, 04:01:01 PM »
Hello Everyone,
I just got at DC-03 DigiSpeed GX V3 to control my chinese C02 laser. I want to use Mach 3 or EMC2.
Has anybody gotten it running? What is the wiring diagram? Which pins do you use on the parallel port?
Here's a picture of it: http://mambohead.com/2011/07/laser-controller-design/
I will get through it eventually but if someone already has it working perhaps they could share what they did?
Thanks in advance!
Darcy
I just got at DC-03 DigiSpeed GX V3 to control my chinese C02 laser. I want to use Mach 3 or EMC2.
Has anybody gotten it running? What is the wiring diagram? Which pins do you use on the parallel port?
Here's a picture of it: http://mambohead.com/2011/07/laser-controller-design/
I will get through it eventually but if someone already has it working perhaps they could share what they did?
Thanks in advance!
Darcy