Messages

21

General Mach Discussion / Re: Spindle

« on: March 22, 2011, 04:22:14 PM »

Signal  Output enabled port 1 Pin 9  Do I need to turn on the spindle in the motor settings? if so What step pin and dir pin.  Under spindle settings. Use spindle ouputs? It clicks when I turn the spindle on, and off, nothing else happens.  No volts no beeps nothing.

22

General Mach Discussion / Re: Spindle

« on: March 22, 2011, 04:12:16 PM »

no nothing is hapening, just says 0.L no matter what I do.  Do I have to turn anything on? do I have to turn on the spindle output.   You will have to be very specific, I have no Idea what I am doing.

23

General Mach Discussion / Re: Spindle

« on: March 22, 2011, 04:05:39 PM »

http://lz4gv.my.contact.bg/CNC_files/3Axis_Driver_txt.pdf

Here is the link, it is the closet thing I have, Looks identical and pins are the same.

24

General Mach Discussion / Re: Spindle

« on: March 22, 2011, 03:51:52 PM »

I have tried that but, I do not know if it is actually on or not, I never get anything over 4v. I can hear it click on and off, but I have no Idea if I even have the correct pins going where they need to.  I only know that pin 9 is for the spindle.

25

General Mach Discussion / Re: Spindle

« on: March 22, 2011, 03:35:29 PM »

No manual just stuff from the internet about the board.  Problem is that some look the same but the manuals are different.  look for 3 axis tb6560 driver board.  I read you what was written on the circuit board for where the spindle should go.

26

General Mach Discussion / Re: Spindle

« on: March 22, 2011, 03:27:55 PM »

on the board for spindle it says (P15 MO/V+) (P16 GND) (P17 M0-).  

27

General Mach Discussion / Re: Spindle

« on: March 22, 2011, 03:23:26 PM »

What do you mean pass through? Take the 2 wires from the motor and put them on the relay? or just one like on a switch, and the other to the power, to complete the circuit.

28

General Mach Discussion / Re: Spindle

« on: March 22, 2011, 02:26:09 PM »

The board is a tb6560, it says it has spindle relays. The board powers my stepper motors nema 23s. My Spindle has no info It is just a DC motor with 2 wires, 7.5 amp. It has a lot of torque,  I can make it go either way with a battery reversing the poles. The only thing I have to go by is that the instructions say that the spindle is pin 9, I know nothing else of what to do. Or even where to put the 9. here is a link to a similar board.  http://cgi.ebay.com/CNC-3-axis-Stepper-motor-Driver-TB6560-INCLUDES-EXTRAS-/290539247321?pt=LH_DefaultDomain_0&hash=item43a57d16d9. 

29

General Mach Discussion / Spindle

« on: March 21, 2011, 11:47:49 PM »

Can some one walk me through the spindle set up. I have been using a router and now have a spindle and do not have a clue how to get it to work.