Hello Guest it is September 26, 2020, 03:49:32 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - lastgo

Pages: 1
General Mach Discussion / Re: xml
« on: January 03, 2011, 06:48:59 AM »
no its not a mach3 XML file but its a file supplied by a manufacturer so if it has errors its there fault but they think the fault is me when flashing the microcontrollers.
so if someone could check the file it would be very much appreciated thanks.

General Mach Discussion / xml
« on: January 03, 2011, 04:58:09 AM »
i have a cnc machine that i bought new but has never worked properly the master and slave boards have been changed three times,
it allways seem to be the z axis board after flashing the xml file I'm now suspicious of the xml file having errors ive checked it with an online validate that says there are three errors but I'm not sure its right.

Pages: 1