Hello Guest it is April 23, 2024, 10:30:46 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - wpy

Pages: 1
General Mach Discussion / Re: PCB Isolation Milling using LazyCam
« on: October 10, 2008, 09:16:06 AM »

Thank you for the replies, especially Greg.

My question really was, have there been any recent changes in LazyCam to support PCB isolation milling.  Before I bought my license for LazyCam (quite some time ago), Art lead me to believe that support was imminent  :).

I don't like/use Eagle and already have a significant investment of both time and money in a competitive product (Easy-PC by Number One Systems).

For your information, DeskPCB from IMService encapsulates the required functionality.


General Mach Discussion / PCB Isolation Milling using LazyCam
« on: October 08, 2008, 07:24:00 AM »

Could anyone please tell me if LazyCam yet supports PCB isolation milling?

Kind regards,


Pages: 1