Topics

1

Forum suggestions and report forum problems. / Printing multi line signs

« on: October 02, 2020, 12:30:25 PM »

I would like to cut multi line signs. Can I use the Load Wizards...Write function to do this?  for instance. If I want to cut
"IT was
a dark and
Stormy night":
load all three line and cut it in one set of G-codes, can I do it from the "Load Wizard.....Write" function? Or do I have to do it one line at a time?

2

G-Code, CAD, and CAM discussions / Mach3 and Keyboard

« on: February 08, 2013, 11:07:47 AM »

I had shut my homebrew CNCrouter down for about a yearand recently fired it up again. Using the same PC, mouse, keyboard, programs etc. However I cn no longer use my up and down keys to move the around the table. I am sure I am missing something, but can find no instructions on the computer or in Mach3 that references the UP/Down arrows (buttons) or configurations.
Any ideas will help and be appreciated.
Thanks PeterJ

3

General Mach Discussion / Uploads from Lazycam

« on: July 10, 2011, 08:16:47 PM »

Uploading from Lazycam to MACH3 has gone haywire. Any DFX files I try to convert to G Codes using Lazycam are not fully loading into MACH3. In fact they only load to 250N and then stop, in all cases. Even older files that were already converted to G Codes only load to 250N. Any program less than 250N load fine. I purchased MACH3 from Artsoft and it is a licensed version. Why would this all of a sudden begin to happen? It worked last Thursday, July 7, but has not worked since. I completely deleted the MACH3 and Lazycam programs and reloaded. Other than IE there are no other programs loaded on this computer.  Any ideas?