Pete here. I am in Jacksonville Florida, no rain and it is hot. But it beats shoveling snow in Cleveland. I built my own CNC Router and it has worked very well so far. I have tried etching, cutting and carving, using many of the free DXF fies available on the various CNC forums. I use Lazycam to convert them to G Codes, allowing me to enlarge or reduce. I then load them using the Load function on MACH3, make minor adjustments if necessary, and run the program. Much success.................until yesterday. For some unknown reason I hope you can help with, Either the Lazycam has stopped creating a complete set of G Codes or MACH3 is not uploading the complete program. Most of the programs converted to Tap prior to yesterday still load 100%, but any new DXF file or even DXF files I saved before yesterday, but did not convert, will not convert 100% to G Codes. The G-code seem to stop and the end of the first chain. Please help. PS I also noticed that some the programs that are embedded in MACH3, such as Circle Cut will no longer work, but Write works fine.]
Pete