Hello Guest it is September 16, 2019, 11:11:25 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Norman Albert

Pages: 1
1
General Mach Discussion / New PC's and parallel ports
« on: December 27, 2010, 07:33:30 PM »
Not Sure where to post this question but here goes. It's getting harder to fine a pc with the old printer 25 pin port. Most new printers only have a USB plug. Is there a work around for this problem? Also, newer mother boards have  the timing vary by a lot. The "specialdriver.bat" does not take care of this problem on the pc's I've tried in the past 2 weeks. The external timing devices are not exactly inexpensive. Norman Albert

Pages: 1