Hello Guest it is March 29, 2024, 02:06:31 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - tiofilo123

Pages: 1
1
General Mach Discussion / Xbox 360 controling the probe
« on: January 08, 2015, 02:09:48 PM »
Hello all, just wondering if anybody has any info as to controlling the probe with the xbox 360, im running the big tex blue  probe screen.  tried looking online with no luck. all I can find are comments about creating macro files which I know nothing about

thanks in advance
Manuel

2
General Mach Discussion / xbox 360 and the touch probe
« on: July 24, 2011, 11:32:37 PM »
hello
im running the blue screen for the tuch probe and i recently hooked up the xbox 360. Is there a way to program the the touch probe x, y, & z to the xbox control?

thanks
Manuel

3
General Mach Discussion / xbox 360 controls not working
« on: July 14, 2011, 11:50:47 PM »
hello all
just installed my xobox 360, read most of the posts and got it installed, Its insalled in mach 3 because i can see it in the plug ins, i checked the  green check mark  to activate it. for some reason none of my controls work.  any suggestion

4
General Mach Discussion / Erratic machine behavior
« on: January 31, 2011, 09:28:30 AM »
hello all
New here to the forum. I'm having problems with my machine, b.t.w. using aspire and saving my toolpaths as gcode*tap inches, x and z axis slowly move and when i try to home back it takes me to a diffrent position than what i originally set it as.  I calibrated the steps at around 3994 for one and 4000 for the other with Machs step calculator, but i could never get true accuracy, for instance, say i asked to move it an inch it moved it to .994 and it would reset it. I would then ask to move again and it would move 1.002 and so on.  it never moved to one inch exactly.  I don't know if this is part of the problem or not.  I am going to crank up the power to my motors, as i was reading that they may be underpowered and skipping steps.  As for now I'm bummed, because i can't use it. I did the tutorial that mach comes with,(roadrunner) and it worked fine. its when i load these 3d's. it goes maadd.  Not sure if its a communication conflict or a calibration adjustment.
My machine is a fla100, by Nate Lowry.  Any thoughts and comments would be appreciated


Pages: 1