Messages

11

General Mach Discussion / Re: Wiring Limit & Home Switch

« on: January 21, 2011, 09:52:31 AM »

Do you have a diagram of wiring the 6 limit switches using shielded cable with 2 conductors w one end grounded thanks

12

General Mach Discussion / Re: Wiring Limit & Home Switch

« on: January 19, 2011, 01:41:51 PM »

Am using a SS

13

General Mach Discussion / Re: Wiring Limit & Home Switch

« on: January 19, 2011, 11:57:53 AM »

Hi hope its ok to break in to this thread? I have simple HCNC using 2 limit switches each on x,y,x cause there is much noise that is activating the switches. I got RS 2 conductor 24ga shielded cable and want to wire them properly. How to utilize the two wires in the cable?
Thanks

14

General Mach Discussion / limits triggered randomly no display

« on: January 16, 2011, 12:12:19 PM »

Finally got the limit switches in Mach 3 to work correctly but now almost randomly all stops as its moving and limit switch error appears and cant reset until I go to settings manual limit reset.
I am wired in series going to gnd and pin 11. Could it be in the home settings. Cannot see anything.No display in Display Mode???

15

FAQs / Re: E stop and Mach 3 help needed

« on: January 06, 2011, 11:04:33 AM »

my problem is how to get rid of the estop error mach3 ss hobbycnc xyz axis limit switches in series going to pin 11