1
General Mach Discussion / Re: DC driver board, terminal abreviations?
« on: April 04, 2011, 08:17:29 AM »
I sent him a message, he said he only had experience with older model bandits. I also posted in the forum, but no reply.
I did a little more testing. I found that if I put any positive voltage to H, with ground of that voltage to lo, or to the machine ground, OR any negative voltage to LO with the positive of that voltage to ground, then - The 100 volts going to the motor I measured goes to 0V.
I am changing a part that maybe defect on the board, I'll let you know what happens after I swapped it.
I did a little more testing. I found that if I put any positive voltage to H, with ground of that voltage to lo, or to the machine ground, OR any negative voltage to LO with the positive of that voltage to ground, then - The 100 volts going to the motor I measured goes to 0V.
I am changing a part that maybe defect on the board, I'll let you know what happens after I swapped it.