Topics

1

General Mach Discussion / Why don't work simulation offline?????Grren pen not showed

« on: February 07, 2007, 05:59:09 AM »

Hello to all first post, i downloaded and installed mach3 demo to test.
I haven't a cnc router at today but want to learn mach3.
After starting mach3 i load the g-code roadrunner then press cycle start but mach3 run few lines and stop here, time elapsed continue to run and zero x, y is 0.0000 :



i check on ports and pins:



but i haven't no device attached so i unchecked all ports.
 
Is there any chance to run/learn mach3 without a cnc router?

Thanks in advance.