Messages

41

Galil / Re: Is it true about Galil plugin?

« on: July 15, 2008, 07:36:11 PM »

Yes they do go green if I home one axis at a time..

Thank you VERY MUCH for your help....

42

Galil / Re: Is it true about Galil plugin?

« on: July 15, 2008, 05:33:13 PM »

The only reason I use the home referance would be for a fixture, in which case I need to ref all axis home.

I also wanted to check up the machine during a very long program...

It does not kill it, it hangs up on the script some how... If you hit the ref all button, it will start with Z but when it touches the switch it will not back off, causing the machine to do nothing until you hit esc... but it will not continue the sequance as it has been stopped...

43

Galil / Re: Is it true about Galil plugin?

« on: July 15, 2008, 12:29:35 PM »

How does it work well? It will not work unless you do one at a time?

44

Galil / Re: Is it true about Galil plugin?

« on: July 15, 2008, 06:03:50 AM »

Limitation?

That doesn't make much since? But your the one who knows...

45

Galil / Re: Is it true about Galil plugin?

« on: July 14, 2008, 07:20:10 PM »

No.. I have the blue screen set

46

Galil / Re: Is it true about Galil plugin?

« on: July 14, 2008, 05:11:16 PM »

Is there any reason that the referance all will start the homing sequence, but after hitting the first switch not back off the switch and lock up the rest of mach.. This is where the esc key is used...

Now if I referance Z then X, Y in any order but one at a time it will work?

Ideas???

47

Galil / Re: Is it true about Galil plugin?

« on: July 12, 2008, 10:48:33 AM »

Ok.... I got it....

lot of choices?

I had 1 of the switches NO, and the others NC....

In the plugin it asks to have them all Active Low....

In ports/pins you have the option for Active low too...

They all have to be the same..... Including the swictches...

I hope this was it, I still do not understand why it ran so well on Sunday and Tuesday?

Btw:Camsoft had really no effect in doing the requested tests....

My suggestion to anyone else... Set all active low in both places, hook the switches up NC (normally closed) because Galil likes NC...

I may be back on this, but all wish me luck......

48

Galil / Re: Is it true about Galil plugin?

« on: July 12, 2008, 07:09:46 AM »

I have a 18x2 4 axis..


Ill try in a few minutes...

49

Galil / Re: Is it true about Galil plugin?

« on: July 11, 2008, 09:02:25 PM »

I do have them on the same computer BUT... When you close Camsoft it completely closes, just like smart term, or wsdk... As if you were to try and run any two of those there would be a huge confilct..

And no because of the 100pin pci card....

50

Galil / Re: Is it true about Galil plugin?

« on: July 11, 2008, 04:55:11 PM »

Ok... I keep trying...

I just restarted the entire system and G0X10Y10Z.25 skips X and Y and only moves Z?

G0Y10 is nothing, but it does say "24 no sequence to begin d" I think this is correct, it may be a little off but thats pretty much what is says.. Next time I am out there I'll WRITE it down....