31
VB and the development of wizards / Re: How to run a script after each Gcode in single step mode
« on: June 21, 2010, 08:05:58 PM »
Thanks for the replies.
I would understand this instead:
G1 X1.000 Y1.000 F50 % No punch
M25
X2.000 Y2.000 % PUNCH
X3.000 Y3.000 % PUNCH
M22
X0.000 Y0.000 % No punch
Regarding the macropump use it really wouldn't actually do motion control or press move with g.code, it will only send a signal to indicate it is time for a punch, and wait for an input signal to acknowledge its completion and then continue with the program.
Is there a way to catch a Gcode the same way M1030 does with M30??
Luis
I would understand this instead:
G1 X1.000 Y1.000 F50 % No punch
M25
X2.000 Y2.000 % PUNCH
X3.000 Y3.000 % PUNCH
M22
X0.000 Y0.000 % No punch
Regarding the macropump use it really wouldn't actually do motion control or press move with g.code, it will only send a signal to indicate it is time for a punch, and wait for an input signal to acknowledge its completion and then continue with the program.
Is there a way to catch a Gcode the same way M1030 does with M30??
Luis