Messages

11

Show"N"Tell ( Your Machines) / Re: The Laser Project.

« on: June 03, 2011, 05:20:35 AM »

here are the photos

12

Show"N"Tell ( Your Machines) / Re: The Laser Project.

« on: June 03, 2011, 05:16:57 AM »

Tweakie good morning.These are the results.
1 st photo  30x30 0,5  20000
2nd    only change the feedrate   7000
3rd   feed        4500

13

Show"N"Tell ( Your Machines) / Re: The Laser Project.

« on: June 02, 2011, 04:29:14 PM »

I ll try it first thing tomorrow.

14

Show"N"Tell ( Your Machines) / Re: The Laser Project.

« on: June 02, 2011, 09:15:05 AM »

could you post a simple test image that you have already tested and your plugin screen(settings).To make a sample on this?

15

Show"N"Tell ( Your Machines) / Re: The Laser Project.

« on: June 02, 2011, 09:09:12 AM »

I will make some samples and posted tommorrow,if this ok!Thanks you very much for your help.

16

Show"N"Tell ( Your Machines) / Re: The Laser Project.

« on: June 02, 2011, 09:05:56 AM »

doesnt make any sense.And why the double image is produced in the one axis(x) direction?I have to mention that my x axis has faster speed than the y axis!

17

Show"N"Tell ( Your Machines) / Re: The Laser Project.

« on: June 02, 2011, 09:03:37 AM »

yes, but if this was the issue why there are two images.If ther was a delay in firing then the one image should be dithered or something like that.The double image in a given space (examle.I have one rectagular 30x30,then in the width axis(x) there are 2 images in the space of 30mm).!

18

Show"N"Tell ( Your Machines) / Re: The Laser Project.

« on: June 02, 2011, 08:49:42 AM »

if i push the " sherline......." the the images are again two. If it was a problem with the laser supply and its reaction speed then I believe that the images should be 4.Very crazy!!!!!!!!!!!!!!!!!!!

19

Show"N"Tell ( Your Machines) / Re: The Laser Project.

« on: June 02, 2011, 08:46:12 AM »

no,everything is as you discribe to your pdf

20

Show"N"Tell ( Your Machines) / Re: The Laser Project.

« on: June 02, 2011, 08:30:52 AM »

Tweakie, thanks for offering your knowledge.Not a long time ago i had bothered you with the problem I had with the double image while trying to engrave!!I still have it .I noticed that as I put the speed up the distance between the two images tend to be bigger.As I told you before i use pwm pulse  from my circuit board to the laser power supply.I have put so much thouht in solving it but nothing. If it was the speed that the pulse or even the power supply reacts to given pulse , then i think that the the images wouldnt be simetrical.Any idea?