Messages

21

VB and the development of wizards / Re: G68 Rotation point?

« on: June 26, 2015, 06:17:22 PM »

Please is there for OEMcode "auto tool zero"external button
Tankyou

22

Finished Screens / Re: Mach3 6 axis screensets for serbians

« on: June 23, 2015, 04:30:23 PM »

aluplastvz@yahoo.com
Pozdrav Zoran

23

Finished Screens / Re: Mach3 6 axis screensets for serbians

« on: June 23, 2015, 06:37:20 AM »

I ja sam okolina

24

Finished Screens / Re: Mach3 6 axis screensets for serbians

« on: June 17, 2015, 02:58:15 AM »

Ja sam to probao bez prikljucenja na masinu samo sam na tastaturi simulirao ,odakle si
Pozdrav

25

Finished Screens / Re: Mach3 6 axis screensets for serbians

« on: June 15, 2015, 05:08:18 AM »

Malo neobicno na drugom racunaru sve radi
Pozdrav

26

Finished Screens / Re: Mach3 6 axis screensets for serbians

« on: June 15, 2015, 02:16:30 AM »

Pozivom odredjene funkcije na ekranu se krece odredjena osa ali se ne zaustavlja  kad se upali lampica da je pipalica ostvarila kontakt
Pozdrav zoran

27

Finished Screens / Re: Mach3 6 axis screensets for serbians

« on: June 11, 2015, 07:53:57 AM »

neznam gde je greska ja sam plobao na tastaturu ne na masini signal za kontakt pipalice se upali kad pritisnem taster koi sam definisao za probe ulaz ali ga ne prepoznaje jednostavno nastavi sa kretanjem
pozdrav

28

Finished Screens / Re: Mach3 6 axis screensets for serbians

« on: June 07, 2015, 02:16:18 PM »

zasto neradi ispitivanje skripta ne prihvata kontakt pipalice svetli signal ali ne reaguje
pozdrav

29

Finished Screens / Re: Mach3 6 axis screensets for serbians

« on: June 07, 2015, 01:51:36 PM »

Odlican posao

30

MACH TOOL BOX / Re: Gcode File section script

« on: June 07, 2015, 01:04:28 PM »

please how to use your example to load the code g
surely that should add a button and the code where you shooting in a Mfunkciju ?
thanks