Guest
Show Posts
31
VB and the development of wizards / Need some help - punch press wizard?
« on: March 11, 2012, 04:43:44 PM »
Hi everyone,
I hope this is the right place to post my question.
I have made two axes for the old punch press my friend uses to punch the holes in aluminum plates.
As he is not very skilled with computers, I'd like to provide the simplest solution possible for him. So I'm interested if there is some sort of wizard that I could use, or is it possible to customize an existing one (like rectangular hole pattern for instance)?
The same tool is used for all the work, only the number of holes and distances in x and y directions change. Unfortunately, I don't have any experience with the development of wizards, so I'd appreciate any help or advice.
Thanks in advance.
I hope this is the right place to post my question.
I have made two axes for the old punch press my friend uses to punch the holes in aluminum plates.
As he is not very skilled with computers, I'd like to provide the simplest solution possible for him. So I'm interested if there is some sort of wizard that I could use, or is it possible to customize an existing one (like rectangular hole pattern for instance)?
The same tool is used for all the work, only the number of holes and distances in x and y directions change. Unfortunately, I don't have any experience with the development of wizards, so I'd appreciate any help or advice.
Thanks in advance.