11
General Mach Discussion / Problem with threading. Can someone help?
« on: September 06, 2023, 11:44:46 AM »
Hello,
i control my lathe with mach3 and the 2 printerports. All works fine, only threading is not possible. When the spindle
turns 50 rounds per minute the indexsignal is 40ms long. The number of turns is nearly correct shown on the screen.
Is the signal to short?
Thanks
Hans
i control my lathe with mach3 and the 2 printerports. All works fine, only threading is not possible. When the spindle
turns 50 rounds per minute the indexsignal is 40ms long. The number of turns is nearly correct shown on the screen.
Is the signal to short?
Thanks
Hans