Hello Guest it is March 28, 2024, 07:57:12 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Figula

Pages: « 1 2
11
General Mach Discussion / Job Loading Out in The Table... Why?
« on: February 07, 2011, 09:46:13 AM »
Why When I load a G-code it places it out in the table and not at homing?

Thanks
Figula

12
Yes! By ;) email, they were back PDQ. FYI the GECKO tech want it back to check to determine if it's the Term. Block or the input relay. "I'll put money on the Guts. Anyway my studio is backed up and I can't do the PA. to CA. to PA. downtime. The GroundHog didn't see his shadow this morning so that means a early spring & that's good news for sign work ;)

Fig     

13
Gecko G540

Figula

14
Hood U R THE MAN! The input on the BOB quit. bummer I really need all 4 inputs I wish I knew what killed it?

Figula

15
 I'll give it a try, Do you think if I reinstall the G540 xml File?
Thanks
Figula

16
OK Is this it?

17
OK Hood attached is the XML you requested. I hope it's what your looking for!

Thanks Figula,

18
 I have the a designated computer for the matchine not connected to the Internet at my shop. How can I do that "Please Advise"
Thanks,
Figula

19
Hood,  When I manually hit a switch the LED's do not go out. and when I try to attach the xml file a window appears telling me it's corrupted. Now What ?

20
Hello all, "Requested home axis home switch is active.. please fix, Then Home.." Everything was homing, soft limits were set and I was routing jobs. And Loving it. All I did different was hooked up a shop-vac to catch dust and Homing stopped  and got the Requested Home Axis message. 

 I have XYZ run in one series to port 1 pin 10.

 Tested all switches & wire for continuity OK

 De-bounced to 2000

 Played with Config. & Reset Homing (Nothing)

 Motors are all lit in Diagnostics

 What can I try Next?

Al

Pages: « 1 2