Messages

1

Mach3 and G-Rex / Re: Setting up new pci card in mach3

« on: November 12, 2010, 02:01:39 PM »

almost same problem just one thing. I wok on Xp. got any solutions?

2

General Mach Discussion / problem with parallel port

« on: November 12, 2010, 02:00:28 PM »

got a new computer wich has no integrated parallel port on it so I instaled paralell port card to connect computer to driver but.. mach3 has no control over card. the adress the it shows in properties is EC00. can u tell me what is the problem?

3

General Mach Discussion / NEWBEE problem with tb6560 and mach3

« on: November 07, 2010, 04:03:50 AM »

hello to everybody

just instaled mach3 and board tb6560. motors have no reaction on software. motors don't move. I allready  have run drivertest. can u give me any suggestions?