Messages

11

Machscreen Screen Designer / Re: Add image is under background

« on: May 15, 2014, 11:38:14 AM »

Gerry,
 Did you ever figure this problem out? As I am having the exact same issue.

12

Works in progress / Re: First Screen Attempt....

« on: April 09, 2014, 08:54:28 AM »

Do you plan to sale it?

13

Works in progress / Re: First Screen Attempt....

« on: April 06, 2014, 11:55:30 AM »

Nice and clean!!!!

14

VB and the development of wizards / Re: Tool plateform Zero find Macro

« on: October 04, 2013, 09:12:12 AM »

Thanks Br549 for the response. The macro's are not something I wrote, they are what I acquired when I bought the A.T.C. 
Not knowing VB I looked through the code on the first macro and didn't see anything that was wierd. If I compared it to the
set Z zero code on the "program run" page the code is displayed kinda the same way. The "Z Plate is grounded" code is under
the " Z axis is now Zeroed" code.    I'm lost.............

The 2nd macro honestly I have know Idea what to look for or where to look.

Thanks Rich

15

VB and the development of wizards / Re: Tool plateform Zero find Macro

« on: September 30, 2013, 08:12:39 AM »

Come on guy's 56 views and no replies. ANY  help would be great!!!

16

VB and the development of wizards / Tool plateform Zero find Macro

« on: September 16, 2013, 12:15:22 PM »

Hey guy's I'm using this Macro to find the top of the Tool pallet that I'm using with a ATC.
But it always say's "Zero plate grounded Or faulty". What's funny is the Macro works, it just that.
I know the Zero plate is working properly because when I use my other Z zero button on the program run screen in
Mach 3 it work's fine. Please look over the Macro to see if something is out of place.

Also at the end of a G-code run I have added a M06 T00 G49 to replace the Tool holder in the Pallet.
Well it replaces it, then it picks it back up for some odd reason and goes to zero. Any help would be greatly appreciated
on this problem.  I've attached the M500 Tool pallet Macro and the START m1ls Macro to look at. Thanks

Rich

17

General Mach Discussion / Macro for finding egde alignment

« on: July 21, 2013, 11:06:17 AM »

Hey guy's looking for a macro to  align material in the Y direction and the X direction.
Like doing a probe on the -Y then retract and go to the +Y direction and give a distance
 the part is out of alignment. Hope this makes sense. I found this picture but can't seem to get
a hold of the owner of it. Crap after looking at it again I need alot of macros.
Or a similar screen that can be added to Mach 3.  Thanks Richard

18

General Mach Discussion / Re: Mach 3 Job Reports

« on: July 12, 2012, 07:24:27 PM »

Thank You very much!! I will try them out tonight.

19

General Mach Discussion / Mach 3 Job Reports

« on: July 11, 2012, 11:15:32 PM »

This has probably been answered a million times, a search showed nothing.But in mach 3  can you setup or name a job and mach 3 keep a record of minutes for that job? Thanks

20

General Mach Discussion / Re: How do you change Programs in MACH 3 File Menu

« on: October 26, 2011, 08:26:47 AM »

Thanks, Hood I try that and they stayed .I thought it might be customized to your taste.
Thanks Rich