Messages

1

General Mach Discussion / Re: How to control the water coolant by mach3?

« on: November 17, 2010, 04:34:51 PM »

 All,
 Thank for the information.
Tweakie,
 I am little puzzled. It's ok for SSR's. Could you pls advise me of the simple circuit  onto SSR's. How to connect onto BOB?

 Mongkol
 

2

General Mach Discussion / How to control the water coolant by mach3?

« on: November 15, 2010, 04:18:36 PM »

Hello Experters,
   I try to control the water coolant by mach3. I buy the water pump (0.5 hp) at 220 volts.
  If I plug 220 volts,the water pump will run immediately.
 I know M-code,M07 is turn on and M09 is turn off for the coolant.
 Who can advise me for  the simple circuit to control the coolant?

 Mongkol

3

VB and the development of wizards / How to write VB to control output signals?

« on: October 17, 2010, 10:07:25 AM »

Dear the experters,
I use mach3 to be CNC software. I am little puzzled on outputs
signals.
I go to config- tap and click ports and pins. Then I choose output
signals.
I can see 20 output signals on the command.
( output#1,output2#,...output#20)
Here's my question
I need to choose output#1, port 1, pin17 with enabled and then,
I need to choose output#2,port2,pin17 with enabled also.
Is it possible to interchange on output with the external
controller of push botton ?

if I press the external of push button one time, output#1 will be
changed from enabled to be no enabled  but output#2 is still to be
enabled.
Or If I press the external of push botton again, output#1 will be
changed to be normally enabled but output#2 is change to be no
enabled. Is it possible ? How to write VB to control output signals ? Pls advise.

Ton

4

General Mach Discussion / How to control the output signals?

« on: October 12, 2010, 11:29:07 AM »

Dear the experters,
I use mach3 to be CNC software. I am little puzzled on outputs
signals.
I go to config- tap and click ports and pins. Then I choose output
signals.
I can see 20 output signals on the command.
( output#1,output2#,...output#20)
Here's my question
I need to choose output#1, port 1, pin17 with enabled and then,
I need to choose output#2,port2,pin17 with enabled also.
Is it possible to interchange on output with the external
controller of push botton ?

if I press the external of push button one time, output#1 will be
changed from enabled to be no enabled but output#2 is still to be
enabled.
Or If I press the external of push botton again, output#1 will be
changed to be normally enabled but output#2 is change to be no
enabled. Is it possible ? How to do it ? Pls advise.

Ton