Hello Guest it is April 19, 2024, 10:02:38 PM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - uglyoldbob

Pages: 1
1
General Mach Discussion / Re: tool properties
« on: October 11, 2010, 08:19:16 PM »
Would that not cause problems if you don't have a center-cutting mill in place and forget the program calls for drilling?

2
General Mach Discussion / tool properties
« on: October 07, 2010, 12:11:29 AM »
Does mach keep track of tools capable of plunging (center cutting or not center cutting) for milling?

Pages: 1