Hello Guest it is May 14, 2021, 07:28:30 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - uglyoldbob

Pages: 1
1
General Mach Discussion / Re: tool properties
« on: October 11, 2010, 08:19:16 PM »
Would that not cause problems if you don't have a center-cutting mill in place and forget the program calls for drilling?

2
General Mach Discussion / tool properties
« on: October 07, 2010, 12:11:29 AM »
Does mach keep track of tools capable of plunging (center cutting or not center cutting) for milling?

Pages: 1