Topics

1

General Mach Discussion / Scripter Compile Errors

« on: November 29, 2011, 06:55:03 PM »

Has anyone seen this error??
I get periodic scriptor compile errors in spindle .mis and when tapping in:M4.mis
Any ideas

2

dspMC/IP Motion Controller / Fixture Offsets

« on: September 30, 2010, 07:24:03 PM »

Tool path displays reversed when fixture offsit is changed from G54 to another offset like G56 after tool change and half the time one axis or another will lose it's position
Any one else ever had this problem?

3

General Mach Discussion / Tool Path display

« on: September 29, 2010, 12:28:54 PM »

Tool path displays correct when program is loaded or regenerated, however when program is actually ran the sines for X and Y reversed and causes soft limit warnings and displays tool path accordingly
system configured using DSPMC plug-in by Vidal Systems
Any thoughts