Hello Guest it is March 28, 2024, 08:32:07 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - 1:1

Pages: 1
1
Hi,

I'm Iooking at these Korean servo stepper/drive units:

http://www.fastech.co.kr/English/Ezi-SERVO.html

Particularly the NEMA34 '86' series steppers - specifications below ... They can go up to 32,000P/R res which can be divided down to 500 - They also claim some impressive advantages over standard stepper drive system, or so they have led me to believe - maybe as a beginner I have been bamboozled by jargon ?  :P

I'd use them firstly in a mill/drill CNC conversion, where they may be over specced (?) - and over priced (?) -  but I will end up using them in other projects also, I'm mainly concerned with what I don't know about the extra costs involved - I imagine a breakout board would be required, which might be cheap enough, but what about 40~70v power supply per axis for 4 axes ?

They'd run open loop with respect to mach3 ? but closed loop internal to themselves ?

Any chestnuts of experience would be greatly appreciated -  Maybe they really are a nice piece of kit ?

Kind Regards,
N




Pages: 1