Hello Guest it is December 02, 2023, 07:15:28 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - tsheehy88

Pages: 1
General Mach Discussion / setting up mach3
« on: November 27, 2014, 09:25:21 PM »
I replaced the computer running a working mill, went through the config menus, calibrated the motors.  Gobs of lights are lit on the control board.  When I jog, the dro's scroll but the machine doesn't move.  What'd I miss?

Pages: 1