1
General Mach Discussion / reverse axis
« on: September 21, 2010, 08:52:50 AM »
hi all,
is there a setup in mach to make my x axis go in the opposite direction after installing a new board the y and z are ok but the x is going the opposite way to what it used to,i have checked the wiring to make sure its the same as the others and it is ok its probably just a daft switch somewhere in mach but i just cant find it, or do i have to turn the motor around?
thank you.
john
is there a setup in mach to make my x axis go in the opposite direction after installing a new board the y and z are ok but the x is going the opposite way to what it used to,i have checked the wiring to make sure its the same as the others and it is ok its probably just a daft switch somewhere in mach but i just cant find it, or do i have to turn the motor around?
thank you.
john