Hello Guest it is March 28, 2024, 07:24:07 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - TRICKEY

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
151
 :-\Hi Steve welcome aboard, chips are by far the easier to clean up, than putting smoke back into the controller best of luck
Dick

152
   Hi Geoff
I am also new to CNC aprx. 12 months and seventy years young just a word of warning CNC  will become addictive

Dick   ;D

153
Thanks Scot will try that,  as I have said I am new to this hobby but boy it is becoming addictive

Dick

154
 :) HI guys
I am new to the cnc world so any help will be appreciated I'm using Mach3 on a quilting frame and have fitted a shuttle pro v2 and downloaded the plug in by Art Fenerty / Scott Shafer thanks Guys it was a "BIG" help.But I now need to programme a button to be able to reverse run can any body help.
trickey

155
 ::)Hi my name is "Richard" only called this when my wife or mother is annoyed most of the time I answer to Dick
I was a diesel engineer, lets just say a long time, I became interested in cnc about 12 months ago after seeing a cnc router in operation.and thought that the idea could be adapted to drive my wife's quilting frame ,which I also designed and built,I now have it thanks to the help of a friend which I meet through CNC zone. is up to the point of copying a pattern eight feet long,I am also a member of the quilting forum.This and other sites like it are a tremendous asset to the world as people of all races and religions can, and do, share
I live in Sydney Australia   

Pages: « 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16