Topics

1

General Mach Discussion / Mach 3 and Sheetcam under linux?

« on: October 22, 2012, 06:11:51 PM »

Can I use Mach 3 and Sheetcam on any linux os like mac osx or ubuntu or pardus?

2

General Mach Discussion / Z axis homing problem

« on: October 21, 2012, 01:37:15 PM »

Hello

I am using cnc plasma and router. And that tables have one controll system so drivers pc etc.

I wasn't using my router for a long time. And I need that today. But I have a some problems. I can't found my mach 3 mill folder. And I reset all of settings. I set all of settings but when I press the go to zero button, Z axis doesn't going to zero. Going to up when pressing the limit switch. I loaded the G-code, pressed the cycle start but that didn't go real measurements. Going to smaller than 40 percent draw and drilling that.

So I ll wait replies. What can be wrong?

Note: I am sorry for my bad english.  

3

Flash Screens / Make a Flash Screen

« on: August 23, 2010, 12:22:34 PM »

I want to make flash screen

But I don't know

how make flash screen and what program use make flash screen

please explain this to me in detail

thanks